Location of the Pellet Fire
Installation of the Enviro Evolution Wood Pellet Burning Heater should be undertaken by an
experienced installer. Please read the Evolution Owners/Technical Manual thoroughly before
commencing installation as failure to follow the instruction could cause damage to the pellet
re or property.
Positioning the re:
Generally the Evolution should be installed in a centrally located position within the home.
When deciding where to position the appliance in your room you need to consider the following:
• Location of a power source
• The Evolution has a convection fan which blows air through tubes in the direction that
the re faces, for optimum performance this location should be in a large room centrally
located.
• The Evolution comes with its own hearth pad. This complies with the hearth requirements
and the re can be installed on a combustible surface.
• The Evolution has been Safety Tested to AS/NZS 2918 using the Davins manufactured
ue. Test Report ARS 05/1185. Installation is not exclusive to these nominated kits,
though alternative ue should only be considered following consultation with your local
council.
• Please consult page 2 for the required clearances to combustible material also ensure
the position of structural elements near the proposed ue.
• Because of the positive pressure in the ue, sealing of all 75mm stainless joints is
mandatory – use high temperature sealant. Both inner and outer ue joints must be
riveted.
• Seismic Restraint: Please see page 6 for requirements.
• Warranty: To validate warranty following installation a copy of the completed Warranty/
Producers Statement must be forwarded to: Switch- Fax (03) 341 8057.
To Next Page
Loading...
Need help?
General
