Parameter & Malfunction
3.1) Press and hold both the power and mode buttons to access
the eScooters parameter settings. (DNA: Do Not Adjust*)
▪ P0: 10 (Wheel Diameter) DNA*
▪ P1: 42 (Battery Voltage) DNA*
▪ P2: 17 (Motor Setting) DNA*
▪ P3: 1 (Motor Setting) DNA*
▪ P4: 1 or 0 (MPH or KM/PH)
▪ P5: 1 or 0 (Kick Start)
▪ P6: 1 or 0 (Cruise Control)
▪ P7: 1 or 0 (Soft or Hard Start)
▪ P8: 100 (Motor Setting) DNA*
▪ P9: 1 or 2 (Electric Assist Braking Strength)
3.2) eScooter malfunction symbols.
Brakes Activated
▪ This symbol will highlight when the R1+ Electric Scooter
Brakes are in use. If this symbol remains on when brakes
are not in use, please see possible faults below.
o Damaged Brake Levers
o Damaged Brake Callipers
o Damage Electrical Brake Cables
o Damaged Electrical Brake Cable Fittings
Motor Fault
▪ This symbol will highlight when the R1+ Electric Scooter
Motor has incurred a fault. If this symbol is activated,
please see possible faults below.
o Damaged Motor Cables
o Damaged Motor Internals
To Next Page
Loading...
