AFTER INSTALLATION THE END USER SHOULD
KEEP THIS GUIDE FOR FUTURE REFERENCE
DO NOT
THROW AWAY
14
• Pairing an extra remote-control:
• Turn the unit off at the isolation point.
• Restore the power to the unit. For 20 seconds from restarting, the
unit will be in pairing mode.
• Press the button on the new remote control once within the 20
seconds and the remote control will pair to the unit.
• If the pairing has succeeded the green LED will light up.
• Replacing the remote-control battery:
• Undo the two screws and remove the rear casing.
• The battery is located behind the front cover. The remote control
requires 1 x CR2032 battery.
• Replace the battery ensuring the correct polarity then replace the
rear cover and screws. The switch will remain paired with the unit
after battery replacement.
• Dispose of the old battery in a safe manner.
To Next Page
Loading...
