ENVO D35 - 5. Operating Your ENVO Electric Bike; 5.1. Basic Ebike Operation

ENVO D35 | ST EBIKE MANUAL | VERSION 1.0 28
5. OPERATING YOUR PRODUCT
5.1. OPERATION
• Your ENVO Electric Bike LCD meter monitors pedal assist, speed, odometer, trip distance,
riding time, and battery energy level. To turn the meter on, press and hold the Power button for
1 second. Make sure the battery is fully inserted into the ENVO Electric Bike, and the on/off
switch is “ON”
• ENVO batteries are equipped with a ve-minute sleep function. If no activity is detected, the
bike will go into “static” mode to conserve battery power. Simply cycle the bike off then on
again to reactivate the battery
• With the display ON, you are ready to select your Pedal Assist mode by using the UP/DOWN
button situated on the controls on the handlebar’s left hand side. Note that the throttle will be
active and power the motor if the assist level is 1 or higher
• ENVO bikes are equipped with a Pedal Assist Sensor installed on the bottom bracket and
senses pedal crank rotation electronically
• Using the UP and DOWN arrows, you can set Pedal Assist from ZERO through 5-speed modes.
One (1) is the lowest, and (5) is the higher boost
• With non-zero Pedal Assist mode, the motor will now turn on when you begin pedaling, and you
will not need to use the throttle. However, you have the ability to increase your speed with the
throttle application while using Pedal Assist mode. Full throttle will be comparable to using the
system on level 5 of assist; hence the throttle will not have any noticeable effect on level 5
• Please note that it takes about a quarter of pedal rotation before Pedal Assist kicks in and turns
on the motor
• To enter walking mode, press and hold the DOWN button for 2 seconds. The ebike will start
moving at a walking speed until you exit the mode by releasing the button
The acceleration provided by the electric motor may feel very uncomfortable at rst. It is best
to start in PAS mode 1 and move up to the faster modes as you become more comfortable
with the acceleration. If you start in the higher modes 3, 4, or 5, the motor kick might cause
panic. In 0 mode, the pedal assist and the throttle are NOT active.