ENVO D35 - Page 34

ENVO D35 | ST EBIKE MANUAL | VERSION 1.0 34
• Make sure that the brake lever does not contact the handlebar when full hand pressure is
applied. If so, then the brakes must be adjusted by increasing the tension on the cable
• You may also adjust the reach on your levers by tuning the screw shown Figure 5F
• With Hydraulic Brakes is it vital they are bled properly and by a certied bike mechanic –
please service and maintain your brakes every 1000 Kilometers or every 6 months or whenever
necessary. Brakes are a critical part of the bike and it is essential that both are working 100%.
• Simply roll down a hill or pedal to about 15km/h and apply brakes till the bike slows down and
repeat about 15 times per lever. DO NOT let the bike come to a complete stop or let the wheels
lock up
• Disc brake rotors become hot during use. Do not touch or come in contact with the disc rotor
shortly after use
• Wet weather will require a longer distance to stop. Brake earlier and avoid sudden stops when
riding in wet conditions
Brakes need bedding in period before reaching max power. Before any serious riding, please
bed in your brakes in a safe location
Figure 5F