ENVO D35 | ST EBIKE MANUAL | VERSION 1.0 43
Error 30H Occurs when green pin
connection comes loose
or disconnected, or pins
become bent
Check the connection,
Pins should be
straight, recconnect if
disconnected
Gear shifter Gears skipping Derailleur not in optimal
position for gear
Adjust derailleur
position with barrel
adjuster located on the
shifter
Brakes Brakes making noise Brake pads are rubbing on
the rotor
Pads need to be
adjusted. Adjust the
cable tension to shift
the left pad, use an
Allen key to adjust the
right pad. The pads
should be adjusted so
the rotor spins freely in
the middle of the two
pads
Brakes not bedded in
properly, material buildup
is causing noise
Lightly sand and clean
rotors and pads. Bed in
your brakes, see section
5.5.
Fenders Front fender is making
noise
Front fender is too close
to the tire and is rubbing
Fender needs to be
adjusted, try lifting it
up and moving it away
from the tire, may need
some slight bending,
make sure you have
secured it in its highest
position
To Next Page
Loading...
