ep EPL185 - Safety Instructions and Standards

REV. 09/2020
A7
1.3 Related Safety Instruction and Standard(For CE)
1.3.1 EN standards
Continuous sound level:
＜
74 dB(A)
according to EN 12053 as stipulated in ISO 4871
The continuous sound level is a value averaged according to standard regulations, taking the
sound pressure level into account when driving, lifting and idling. The sound pressure level is
measured at the ear.
Electromagnetic compatibility (EMC)
The manufacturer confirms compliance with the limit values for electromagnetic emission and
interference immunity as well as testing of static electricity discharge according to EN 12895 and
the references to other standards contained therein.
Electrical or electronic components and their arrangement may only be modied after written
approval by the manufacturer has been obtained.
1.3.2 Conditions for application
Working condition requirements:
– Use in specied rated load.
– Used in specied area as factory, tourist attraction and recreation place.
– Used on the at ground, that is xed and owns enough carrying capacity.
– It is prohibited to pass the bulge or cavity as the small wheel diameter may cause truck tipping
over.
– Used on the road with good vision and equipment use license.
– The truck's maximum operation altitude is up to 2000m.
– Trucks can only be operated in adequately illuminated working areas to avoid injuries. In case
of insu󰀩cient light, an additional lighting equipment is needed to ensure that the driver can see
properly.
If you must travel on an incline, the gradients should be below A% at full load, or below B%
without a load.(For the value of A and B, refer to the Gradability in technical data)