ep EPL185 - Page 57

REV. 09/2020
D2
If the fault cannot be rectied after carrying out the remedial procedure, notify the Manfacture's se-
vice department, as any further troubleshooting can only be performed by specially trained and
qualied service personnel.
Fault Probable Cause Action
Truck does
not start.
–Battery connector not plugged
in
–Key switch in “0” position
–Incorrect CanCode code
–Battery charge too low
–Faulty fuse
–Truck in charge mode
–Check the battery connector and
connect if necessary.
–Set key switch to “I”
–Check code
–Check battery charge, charge battery
if necessary
–Check fuses.
–Interrupt charging
Load cannot
be lifted
–Charging capacity below 15
％
–Truck not operational
–Hydraulic oil level too
low
–Faulty fuse
–Charging the battery
–Carry out all measures listed under
“Truck does not start”
–Check the hydraulic oil level
–Check fuses.
Troubleshooting
Spare parts:
Only original spare parts have been certied by our quality assurance department. To ensure
safe and reliable operation of the Pallet truck, use only the manufacturer's spare parts. Used
parts, oils and fuels must be disposed of in accordance with the relevant environmental protection
regulations. For oil changes, contact the manufacturer’s specialist department.
Safety tests to be performed at intervals and after unusual incidents
The truck must be inspected at least annually (refer to national regulations) or after any unusual
event by a qualied inspector. The manufacturer o󰀨ers a safety inspection service which is
performed by personnel specically trained for this purpose.
A complete test must be carried out on the technical condition of the truck with regard to safety.
The truck must also be examined thoroughly for damage.
The operating company is responsible for ensuring that faults are rectied immediately.