EPH Controls COMBIPACK4 - To connect the RFRP-OT thermostat to an RF1 A-OT receiver; On the RF1 A-OT receiver; On the RFRP-OT thermostat

51
CombiPack4
Please note, If you are installing a CombiPack4 the RFRP-OT thermostat
and the RF1A-OT receiver will have a pre-established RF connection so it is
not necessary to carry out the RF connection process below.
To connect the RFRP-OT thermostat
to an RF1A-OT receiver
On the RF1A-OT receiver:
Press the
Connect
button.
The red light will begin to ash.
On the RFRP-OT thermostat:
Press the
button.
The thermostat will show ‘OE’ followed by ‘---’
Once an RF connection has been established the thermostat will show
‘r01’ on the LCD screen.
Press the
OK
button to nish the process.
The thermostat is now connected to the RF1A-OT receiver.