17000 X-Axis Assembly Replacement
3
X-Axis Assembly
Replacement
X-Axis Assembly Removal
1. Turn o the engraver.
2. Disconnect the engraver from power
source.
3. Remove the le and right panels of the
engraver:
4. Loosen and remove the lens tube
assembly from the x-axis assembly:
5. Remove the x-axis drive board cover:
6. Disconnect the air assist tubing from
the right side of the x-axis assembly:
The AA tubing is held by a tubing coupler.
To remove the tubing, press the tubing
into the fixture. Then, while holding the
retaining ring tight to the fixture, pull the
AA tubing away from it.
To Next Page
Loading...
