Epilog Laser Fusion User Manual

Adjusting the Table Level
Fusion and FiberMark Fusion
Revision Date: 9/10/2014 pg. 1 of 10
EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-215-9171
FAX 303-277-9669
www.epiloglaser.com
Adjusting the Table Level
For the Epilog Fusion and FiberMark Fusion
9/10/2014
Requirements:
Tools:
• 3/32” Allen Wrench
• Manual Focus Gauge
When to use this document:
• Uneven power in various areas of the table.
• Reduction in quality in various areas of the table.
• General reduction in power or quality.
• Inconsistent or Inaccurate Auto Focus.
• When instructed by Epilog Tech Support.
Overview:
This procedure will guide you through the process of properly checking and
adjusting the table level on the Epilog Fusion. This will ensure proper focus on every
point of the engraving area.

Epilog Laser Fusion Specifications

General

Laser Type	CO2
Max Material Thickness	12.25" (311 mm)
Resolution	Up to 1200 DPI
Connectivity	Ethernet, USB
Operating Modes	Raster, Vector or Combined
Interface	Touchscreen control panel
Power Supply	110V or 220V, depending on model
Cooling	Water-cooled laser tubes
Software	Epilog Laser Dashboard
Supported File Formats	AI, BMP, DXF, EPS, GIF, JPG, PDF, PLT, PNG
Warranty	1 year limited warranty
Z Table Travel	Varies by model (typically 12 in)
Exhaust	Required, external blower recommended

Summary

Adjusting the Table Level

Procedure A: Check Table Level

Guides through checking the table level using the manual focus gauge.

Determining Which Corners Need to Be Leveled

Identifies which corners require adjustment based on the reference corner.

Procedure B: Adjusting the Front Corners

Details the steps for adjusting the front corners of the table level.

Procedure C: Adjusting the Rear Corners

Details the steps for adjusting the rear corners of the table level.