Epilog Laser Fusion User Manual

Adjusting the Table Level
Fusion and FiberMark Fusion
Revision Date: 9/10/2014 pg. 3 of 10
Step 3: Focus on Reference Corner
Use the Up and Down Arrow Keys on the Key Pad to place the engraver into
Focus mode. Use the Joystick to move the Table until it just touches the Manual Focus
Gauge.
Step 4: Check Focus on Each Corner
Use the Up and Down Arrow Keys on the Key Pad to place the engraver into Jog
mode. Use the Joystick to move the Lens Carriage to each corner of the engraver. If the
table is still barely touching the Manual Focus Gauge in each corner, the table level is
good. If the table drops away or rises up as you move the Lens Carriage, please
continue to the next procedure.

Epilog Laser Fusion Specifications

General

Laser Type	CO2
Max Material Thickness	12.25" (311 mm)
Resolution	Up to 1200 DPI
Connectivity	Ethernet, USB
Operating Modes	Raster, Vector or Combined
Interface	Touchscreen control panel
Power Supply	110V or 220V, depending on model
Cooling	Water-cooled laser tubes
Software	Epilog Laser Dashboard
Supported File Formats	AI, BMP, DXF, EPS, GIF, JPG, PDF, PLT, PNG
Warranty	1 year limited warranty
Z Table Travel	Varies by model (typically 12 in)
Exhaust	Required, external blower recommended