Epilog Laser Helix Replacing Instructions

EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-215-9171 - FAX 303-277-9669
www.epiloglaser.com
Procedure Title: Replacing the X-Axis assembly
Machine Type: Helix
Tools Needed: Philips head screw driver
Wire Snips
Intro:
This procedure details steps to removing the I-beam.
1. Unplug the power cord from the machine
2. Remove both side panels. There are four screws on the
side and two screws on the back of the machine for
each panel.
Left Side Right Side

Epilog Laser Helix Specifications

General

Laser Type	CO2
Resolution	up to 1200 dpi
Cooling System	Air-cooled
Software	Epilog Dashboard
Warranty	2 years
Laser Power	30, 40, 50, 60 watts
Max Material Thickness	8" (203 mm)
Connectivity	USB
Operating System Compatibility	Windows
Operating Modes	Raster, Vector, Combined
Power Supply	50/60Hz
Supported File Formats	AI, EPS, PDF, DXF, BMP, GIF, JPEG, PNG, TIFF
Work Area	24" x 18" (610 x 457 mm)