12
Connect the water supply hose of the
toilet tank and the water inlet hose of the
toilet seat to the three-way angle valve as
shown in the figure.
Connect the hoses6.
Connect the water inlet
hose of the toilet seat
Connect the water supply
hose of the toilet tank
the water supply hose
of the toilet tank
the water inlet hose
of the toilet seat
5. Screw installation
Put the screw through the fixing sleeve
and then install it through the holes (on
both sides of the toilet bowl) to the
mounting bracket on the ground. Lock
tight.
Install the decorative cap on the fixing
sleeve.
Fixing sleeve
Screw
Decorative cap
To Next Page
Loading...
