Epomaker EK75 - Wireless Connection Guide; Bluetooth Pairing Procedure; 2.4 GHz Dongle Setup; Wired Mode and Charging

PAIRING BLUETOOTH
Toggle the switch to the left, make sure that the keyboard is under the
wireless mode:
1.Hold Fn+Q/W/E for 3-5 seconds till the light bar flashes fast in blue, the keyboard
is ready to pair.
2. Turn on your Bluetooth device and find 'Epomaker EK75-1/2/3', then connect.
When the keyboard is connected to the Bluetooth device, the light bar stops
flashing, the connection is done.
3. Press Fn+Q/W/E to toggle between the Bluetooth devices 1/2/3.
PAIRING WIRELESS 2.4GHZ
Toggle the switch to the left, make sure that the keyboard is under the
wireless mode:
1.Toggle the switch to 2.4G mode (the indicator flashes white when entering to the
2.4G mode), the keyboard is ready to pair.
2. Insert the 2.4G dongle to your device, the indicator stops flashing white and the
connection is done.
3. Reconnect 2.4G mode: Hold Fn+R for for 3-5 seconds till the light flashes white, the
keyboard is ready to pair.
WIRED MODE
After plug the keyboard, press Fn+T, and the keyboard enters to the wired mode
successfully.
The battery charges under either wireless or wired mode, as
Note:
long as it is plugged.