EPOX EP-8RDAE - Page 51

BIOS
Page 4-15
Password: Requires you to enter a password when using the keyboard
to power on. Set the password in the next field KB Power ON
Password.
Hot KEY: Enables you to use a hot key combination to power on the
computer. Set the hot key combination in the Hot Key Power
ON field.
Any KEY: Enables you to set any keyboard activity to power on the
computer.
BUTTON ONLY: Requires you to push the computer power button to power on
the system.
Keyboard 98: Enables you to set the Windows 98 key to power on the system.
Keyboard Power ON Password
Press Enter to create a password that is required when you use the keyboard to
power on the system. You must set the POWER ON Function to Password to be
prompted for a password at power on.
Hot Key Power ON
Enables you to set a hot key combination to be used for powering on the system.
The default is Ctrl-F1.
Options: Ctrl-F1 ~ Ctrl-F12.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has no
floppy drive, select Disabled in this field.
Options: Enabled, Disabled.
Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first and second serial ports.
Options: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This field is to configure which IR mode the 2nd serial port should use. The default
is Normal.
Options: Normal, IrDA and ASKIR.