2
communication protocol compatibility much better
Support firmware upgrade
3 Installation Instructions
3.1 General Installation Notes
Be very careful when working with batteries. Wear eye protection.
Have fresh water available to wash and clean any contact with
battery acid.
Never short circuit the battery positive and negative terminals and
wires which may cause explosion or fire.
Install external fuses/breakers as required.
Disconnect the solar module and fuse/breakers near to battery
before installing or adjusting the controller.
Confirm that power connections are tightened to avoid excessive
heating from loose connection.
Uses insulated tools and avoid placing metal objects near the
batteries.
Explosive gasses may be present during charging. Be certain there
is sufficient ventilation to release the gasses.
Avoid direct sunlight and do not install in locations where water can
enter the controller.
Loose power connections and/or corroded wires may result in
resistive connections that melt wire insulation, burn surrounding
materials, or even cause fire. Ensure tight connections and use
cable clamps to secure cables and prevent them from swaying in
mobile applications.
Only charge the batteries that comply with the parameters of
controller.
Battery connection may be wired to one battery or a bank of
batteries. The following instructions refer to a singular battery, but it
is implied that the battery connection can be made to either one
battery or a group of batteries in a battery bank.
Select the system cables according to 3.5A/mm
2
current density.
To Next Page
Loading...
