Epson 1680 - Setting the Terminator Switch

Expression 1680/1680 Pro
A5-Format Quick Start Manual_E.fm
3/6/01 Right page
R
17
EN
■ Setting the terminator switch
The scanner has a built-in terminator, which allows SCSI devices to communicate
properly with each other. Depending on your computer system, you may need to change
the terminator switch setting.
Note:
Do not use an external terminator.
The terminator switch is located
at the rear of the scanner.
Only the scanner is connected
terminator on
The scanner is the last device in the daisy chain
(other SCSI device)
terminator on
The scanner is in the middle of the daisy chain
terminator off
(other SCSI device)