Clearing Jammed Paper (4/9)
EPSON AcuLaser C8600 Quick Reference
Paper Jam - Cover B (Jam B)
When paper is jammed at the fuser unit, the
LCD panel displays the Jam B error message.
Follow these steps to clear paper jams in the
fuser unit.
1. Pull the fuser unit out gently until it
stops. Be careful not to tear the jammed
paper.
w
Warning:
Do not insert your hand deep into the
fuser unit (unit B) as some
components are sharp and may cause
injury.
2. Pull the lever up to release the paper
path.
w
Warning:
Do not touch the fuser, which is
marked CAUTION! HIGH
TEMPERATURE, or the surrounding
areas. If the printer has been in use,
the fuser and the surrounding areas
may be very hot.
3. Turn the knob in the fuser unit to eject
the jammed paper.
4. Gently remove the jammed paper with
both hands. Be careful not to tear the
jammed paper.
Note:
❏ Be sure to remove the jammed paper by
pulling it upward.
❏ If paper is torn, be sure to remove all torn
pieces.
If the Duplex unit is attached, follow the
next step. If you see the paper remaining
but cannot remove it, open the cover and
remove the paper as shown below.
To Next Page
Loading...
