Epson AcuLaser CX11NF - Adjusting the Contrast; Enlarging or Reducing the Copy Size; Adjusting the Color

38 Copying
Adjusting the Contrast
You can adjust the image contrast by selecting from 7 levels (–3 to 3). The higher the
level, the greater the contrast. When you lower the contrast, the difference in dark and
light areas decreases. The default level is 0.
1. Make sure the product is in Copy mode. If not, press the Copy button.
2. Press the d button several times to select Contrast.
The current Contrast value is highlighted.
3. Press the r button to increase the contrast. Press the l button to decrease the
contrast.
Adjusting the Color
You can adjust the image colors by selecting from 7 levels (–3 to 3) for red (R), green
(G), and blue (B). The higher the level, the richer the color. The default level is 0.
Note:
RGB adjustment is available only for color copies.
1. Make sure the product is in Copy mode. If not, press the Copy button.
2. Press the u or d button several times to select a color (R, G, or B). The current R,
G, or B value is highlighted.
3. Press the r button to increase the color strength. Press the l button, to decrease
the color strength.
Enlarging or Reducing the Copy Size
You can adjust the copy size by selecting a specific zoom ratio or a specific percentage
for enlargement or reduction (25 to 400%). The default zoom ratio is 100%.
1. Make sure the product is in Copy mode. If not, press the
Copy button.
2. Press the u or d button several times to select Zoom. The current Zoom value is
highlighted.
Basic.book Page 38 Monday, August 22, 2005 12:35 PM