EasyManuals Logo

Epson BrightLink 450Wi Using

Epson BrightLink 450Wi
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Using the Wall-Mounting Cable Management Kit
Follow these instructions to install the cable management channels on your wall and place the cables in the
channels.
The Wall-Mounting Cable Management Kit includes the parts shown below:
1 Plan your cable management layout, referring to the illustration below. If you want to connect two 4-foot
channels together (end-to-end), use a seam cover where the channels meet. Use the small connector pieces
to turn corners. Use a hacksaw to cut the channels and channel covers to desired lengths.
Tip
When using a hacksaw, cut the plastic slowly to maintain smooth edges.
Note
The example shown below is for a typical installation, but yours may vary. For example, if the computer is on the right
side of the screen, you should attach the channels to the wall on the right side instead of the left.
Corner connector
(3 pieces)
Seam cover
(10 pieces)
4-foot-long channels
(4 pieces)
Drywall screws
(100 pieces)
18-inch-long channel
(1 piece)
Corner
connector
Seam
cover

Other manuals for Epson BrightLink 450Wi

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson BrightLink 450Wi and is the answer not in the manual?

Epson BrightLink 450Wi Specifications

General IconGeneral
BrandEpson
ModelBrightLink 450Wi
CategoryProjector
LanguageEnglish

Related product manuals