Epson BrightLink 695Wi+ - Install the Touch Unit

30
E Install the Touch Unit
• For magnetic boards, place the back of the Touch Unit on the screen surface to secure it.
• For non-magnetic boards or screens, attach the spacers to the screw holes on the back of the Touch
Unit.
Secure the Touch Unit with three (3) M4 screws (not included).
When installing the Touch Unit on a magnetic surface, be careful not to trap your fingers or any
other part of your body between the magnets and the installation surface.
Caution
1.7 in. (43 mm)
0.8 in. (20 mm)