Epson BrightLink 695Wi+ - Remove the Front Cover

41
English
If you are using the Touch Unit, make sure that you do not install the Control Pad or Pen Stand in the shaded
areas of the following figure. The Touch Unit will not operate correctly if anything is obstructing the infrared
signal.
A Remove the front cover
B Attach the Control Pad
Attach the Control Pad with commercially available M4 × 20 mm screws (×4).
0.8 in. (20 mm)
4.0 in. (100 mm)4.0 in. (100 mm)
❏ Make sure the screws are not angled.
❏ Make sure the Control Pad is firmly attached.
❏ Do not attach the Control Pad with double-side tape or magnets.
Warning