5. Install the Media
You must set the printer driver settings in
Windows to your badge specifications before the
next steps. Video available in the QR code below.
a. For Fanfold Badge Stock, lift the back lid of
the printer (and if needed lift the blue lever
to adjust for the media with.) The paper
should be tight and straight behind the
printer. See below.
b. Make sure the badge stock orientation is
correct. e.g., Black timing mark facing down,
leading first with arrows facing towards the printer.
c. Carefully feed the badge stock into the
back of the printer until it comes to a stop
and the printer fans turn on and you can
hear them. Do Not push the badge stock too hard.
d. The printer Pause light will turn on orange.
Push the Pause button and the printer will
feed one badge.
Scan this QR Code to see step
by step how to load the
fanfold badge stock.
a. For Roll Badge Stock, open the front
door by pulling the dark grey latch.
Now remove the “Paper Feed Guide”
as shown below. (clear grey plastic
piece)
b. Raise the lock lever on the inside of
the printer (left side) and adjust the
width of the Roll Guide. See below.
c. Insert the Roll to have it feed paper
over its top, not the bottom. Pull some
badge stock out.
d. Push the blue latch down to lock it in
place.
e. Close the front panel leaving a bit of
paper sticking out.
f. Push the Pause button and the printer
will feed a badge and/or calibrate.
To Next Page
Loading...
