6. Exchange empty Ink cartridges.
The printer comes with Ink cartridges pre-
installed. Follow the steps below to replace
empty Ink cartridges. MUST only be done while
the printer is not being used and is in “ready” state.
e. Open the front right panel of the printer. Do
not send any commands or turn off the printer.
f. Push the light blue lever inward to release
the cartridge from the printer then pull it out.
g. Shake the new Ink cartridge horizontally for
about 5 seconds before removing it from its
packaging. Do not touch the IC chip in the
cartridge.
h. Insert the cartridge into the designated slot.
(KCMY) Push on the ink cartridge with your
fingertip until it clicks into place. Close the ink
door. The printer will proceed to run the ink.
Please DO NOT Return the printer
without INK cartridges installed to
avoid physical damage to the unit.
INK Cartridges should always be
inside the printer, even in transit.
7. Install the Dispense Tray to the hooks
on the bottom of the paper ejection
guides.
8. Adjust the Dispense Tray length by
pulling out the dark grey lever on the
right side of the Dispense Tray. Extend
the tray until the paper length indication
matches with the length of your paper.
9. Lock tray in place by pushing in the
dark grey lever at the bottom.
To Next Page
Loading...
