TM-C3400 User’s Manual 13
English
Removing fanfold paper
1. Remove the paper left on the paper ejection table.
2. When you change the paper type, open the roll paper cover and
the fanfold paper
cover to remove the paper.
3. Close the roll paper cover and the fanfold paper cover.
➁ Setting paper position detection
When paper position detection setting does not need to be changed,
skip this step. Use the printer driver for this setting.
1. Turn on the printer.
2. Change [
Paper Position Detection] on the [Maintenance And
Utilities
] tab of the printer driver depending on the paper to use.
Note:
For information on how to display the
printer driver, see page 20.
3. Turn off the printer.
CAUTION:
The changed setting of the paper position detection is stored in the
printer when the printer is turned off. Be sure to turn off the printer to
enable the setting.
To Next Page
Loading...
