120 Problem Solver
The printer does not print when the computer sends data.
Cause What to do
The printer is paused. Press the Pause button to turn off the
Pause light.
The interface cable is not
plugged in securely.
Check that both ends of the cable
between the printer and the computer
are plugged in securely. If the cable is
connected correctly, run a self test as
described in “Printing a Self Test” on
page 110.
Your interface cable does not
meet the printer and/or
computer specifications.
Use an interface cable that meets the
requirements of both the printer and
computer. See “Electronic” on page 171
and your computer documentation.
Your software is not properly
set up for your printer.
Select your printer from the Windows
desktop or in your application. If
necessary, install or reinstall the printer
driver software as illustrated in the Start
Here.
The printer makes noise, but nothing prints or printing stops
abruptly.
Cause What to do
The ribbon has too much slack,
the ribbon has come loose, or
the ribbon cartridge is not
installed properly.
Remove any slack in the ribbon by
turning the ribbon-tightening knob, or
reinstall the ribbon cartridge as
described in the section under
“Replacing the Ribbon Cartridge” on
page 134.
To Next Page
Loading...
