Safety Instructions 9
1
1
1
1
1
1
1
1
1
1
1
1
❏ If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by a 16-amp circuit breaker.
When Handling the paper
❏ Never feed labels backward using the Micro Feedd button.
When fed backward, labels can easily peel off the backing
sheet and cause a paper jam.
❏ Because labels are sensitive to temperature and humidity, use
them only under normal operating conditions described
below:
❏ Do not leave labels loaded in the printer between jobs; they
may curl around the platen and jam when you resume
printing.
❏ Do not load paper that is curled or has been folded.
Temperature 15 to 25°C (59 to 77°F)
Humidity 30 to 60% RH
To Next Page
Loading...
