Epson DLQ-3500 - Page 2

Buttons and Lights (2/2)
EPSON DLQ-3500 Quick Guide
5 Paper Source button
Selects a paper source.
Tractor light
On when continuous paper is
selected.
Manual/CSF light
On when single-sheet is selected.
6 LF/FF button
❏ Feeds paper line by line when
pressed shortly.
❏ Ejects a single sheet or advances
continuous paper to the next
top-of-form position when held
down for a few seconds.
7 Load/Eject button
❏ Loads a single sheet of paper.
❏ Ejects a single sheet of paper if a
sheet is loaded.
❏ Loads continuous paper from
the standby position.
❏ Feeds continuous paper
backward to the standby
position if a sheet is loaded.
8 Micro Adjust
When you hold down the Pause
button for three seconds, the printer
enters the Micro Adjust mode. In this
mode, you can adjust the top-of-form
and tear-off positions by pressing the
LF/FF D and Load/Eject U buttons.
See “Micro Adjust Function.”
9 Paper out light
❏ On when no paper is loaded in
the selected paper source or
paper is not loaded correctly.
❏ Flashes when paper has not been
fully ejected or a paper jam has
occurred.
10 Pause button
❏ Stops printing temporarily, and
resumes printing when pressed
again.
❏ When held down for three
seconds, enters the Micro Adjust
mode. When pressed again, exits
the Micro Adjust mode.
Pause light
❏ On when the printer is paused.
❏ Flashes when the printer is in the
Micro Adjust mode.