Epson DLQ-3500 - Chapter 1 Paper Handling; Chapter 2 Printer Software

Default Settings (1/4)
EPSON DLQ-3500 Quick Guide
Default Settings
Understanding default settings
This section describes the settings and
options available in the default-setting
mode. These settings are shown in the
following table and explained in detail after
the table.
Default-setting mode
* This setting is available only in IBM PPDS emulation
mode.
** The options available for this setting vary
depending on the country.
Setting Options
Page length for tractor Length in inches: 3, 3.5, 4,
5.5, 6, 7, 8, 8.5, 11, 70/6,
12, 14, 17
Skip over perforation Off, On
Auto tear-off Off, On
Auto line feed Off, On
Print direction Bi-D, Uni-D, Auto
Software ESC/P2, IBM PPDS
0 slash 0, (the zero character
with a slash)
High speed draft Off, On
I/F (interface) mode Auto, Parallel, USB,
Option
Auto I/F (interface)
wait time
10 seconds, 30 seconds
Parallel I/F bidirectional
mode
Off, On
Packet mode Auto, Off
Auto CR (carriage
return)*
Off, On
A.G.M* Off, On
0
/
Character table Standard model: italic,
PC437, PC850, PC860,
PC863, PC865, PC861,
BRASCII, Abicomp,
Roman8, ISO Latin 1,
PC858, ISO 8859-15
All other models: Italic,
PC437, PC850,
PC437 Greek, PC853,
PC855, PC852, PC857,
PC864, PC866, PC869,
MAZOWIA, Code MJK,
ISO 8859-7, ISO Latin 1T,
Bulgaria, PC 774, Estonia,
ISO 8859-2, PC 866 LAT.,
PC 866UKR, PC APTEC,
PC708, PC720, PCAR 864,
PC860, PC865, PC861,
PC863, BRASCII,
Abicomp, Roman8,
ISO Latin 1, PC858,
ISO8859-15, PC 771
International
character set for italic
table**
Italic U.S.A., Italic France,
Italic Germany, Italic U.K.,
Italic Denmark 1, Italic
Sweden, Italic Italy, Italic
Spain 1
Font OCR-B, Orator, Orator-S,
Script C, Roman T, Sans
Serif H
Manual feed wait time 0.5 second, 1 second, 1.5
seconds, 2 seconds
Buzzer Off, On
Overlapping Forms Off, On
Setting Options