Epson DX5 X 1 - Page 10

10
Chapter
Chapter
Chapter
Chapter 7.
7.
7.
7.
Software
Software
Software
Software Calibration
Calibration
Calibration
Calibration
1. Nozzle checking: P rint the nozzle checking to check the condition of the printhead.
Make
Make
Make
Make sure
sure
sure
sure to
to
to
to turn
turn
turn
turn off
off
off
off the
the
the
the Eclosion
Eclosion
Eclosion
Eclosion (Feather)
(Feather)
(Feather)
(Feather) function
function
function
function before
before
before
before doing
doing
doing
doing the
the
the
the alignment.
alignment.
alignment.
alignment.
2. Vertical calibration: Observe the physical alignment of printheads.
（ This
This
This
This step
step
step
step is
is
is
is not
not
not
not aligned
aligned
aligned
aligned well
well
well
well which
which
which
which will
will
will
will affect
affect
affect
affect the
the
the
the following
following
following
following adjustment
adjustment
adjustment
adjustment ）
Align the physical vertical position of printhead.
The first pass line is the reference; observe whether the second pass line is perfectly aligned with the first
pass line. If not, then we need to adjust the carriage plate. There are 3 situations:
1) The two pass is perfectly aligned, no need to adjust:
2) The second is on the left side of the first pass:
Adjust method:
A. Loosen the 3 screws on the carriage plate:
B. Turn the screw clockwise:
First pass
Second pass
First pass
Second pass