Setting Up Monitoring Using SNMP
115
Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Configuration and press [Enter].
c
Select the Notifications menu and press [Enter].
d
Set the SNMP setting to On.
e
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
a
Do not use these addresses: 224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). This projector supports
SNMP agent version 1 (SNMPv1).
f
Enter the SNMP Community Name up to 32 alphanumeric characters
long.
g
When you finish selecting settings, select Complete and follow the on-
screen instructions to save your settings and exit the menus.
gg Related Links
• "List of Functions" p.10
To Next Page
Loading...
Need help?
General
