Installing the Touch Unit
108
b
Select Touch Unit Setup (Auto)
c
Select whether or not the Touch Unit Bracket is being used
c
•
The following steps differ if you are using an older model of Touch Unit. Follow the on-screen
instructions. For details on performing operations, see the Installation Guide supplied with the
old projector.
•
If the screen for an older model Touch Unit is displayed even though the ELPFT01 is connected,
check the connection for the Touch Unit connection cable.
d
If you are using the Touch Unit Bracket, turn the adjustment screw on the top of the bracket
counterclockwise until you cannot turn it any further
To Next Page
Loading...
