A
Extend the rear foot.
B
Retract the rear foot.
Correcting the Focus
You can correct the focus using the focus ring.
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] button on the control panel or the remote control
to adjust the volume.
[
a] Decreases the volume.
[
b] Increases the volume.
Using the remote control Using the control panel
• Adjust the volume from the Configuration menu.
s Settings - Volume p.80
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume
before powering off, so that you can power on and then gradually increase the
volume.
Selecting the Projection Quality (Selecting Color
Mode)
You can easily obtain the optimum image quality simply by selecting the
setting that best corresponds to your surroundings when projecting. The
brightness of the image varies depending on the mode selected.
Mode Application
Dynamic
Ideal for use in a bright room. This is the brightest
mode, and reproduces shadow tones well.
Adjusting Projected Images
40
To Next Page
Loading...
Need help?
General
