Epson EB-G6750WU - ID Settings

A
Extend the rear foot.
B
Retract the rear foot.
Attention
The rear feet can be attached and removed. Note that the feet will detach if
they are extended more than 10 mm.
ID Settings
When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors.
a
• Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Remote control operating range" p.15
• When Remote Control Type is set to Simple from Operation in the
configuration menu, you cannot set the remote control ID.
s p.86
• IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
Set the projector ID
a
Press the [Menu] button while projecting.
s
"Using the Configuration Menu" p.78
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [ ] button.
d
Select the ID you want to set, and then press the [ ] button.
e
Press the [Menu] button to close the configuration menu.
Installing the Projector
28