98
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson
Projector Management software.
6. When you are finished selecting settings, select Complete and follow the on-screen instructions to
save your settings and exit the menus.
7. Turn off the projector, then turn it on again to enable the setting.
8. Start your Web browser on a computer or device connected to the network.
9. Go to the Epson Web Control screen by entering the projector's IP address into the browser's
address box.
10. Select the Crestron Connected settings. See the Crestron Web site for details.
Parent topic: Using Crestron Connected
Related references
Projector Setup Settings - Extended Menu
Controlling a Networked Projector Using Crestron Connected
Once you have set up your projector to use Crestron Connected, you can control and monitor your
projector using a compatible web browser.
1. Start your web browser on a computer connected to the network.
2. Type the projector's IP address into the browser's address box and press the computer's Enter key.
You see the Epson Web Control screen:
To Next Page
Loading...
Need help?
General