Epson EcoTank ET-2550 - Page 24

4. Slide the edge guide to the edge of the paper, and then close the feeder guard.
5. Check the paper size and paper type settings displayed on the control panel. To use the settings, select Do Not
Change using the
u or d button, press the OK button, and then go to step 7. To change the settings, select
Change using the
u or d button, press the OK button, and then go to the next step.
c
Important:
e paper setting screen is not displayed if the paper is not loaded along the right side of the rear paper feed. An
error occurs when you start printing.
Note:
e
paper setting screen is not displayed if you have disabled Paper
Conguration
in the following menus. Go to step 7.
Setup > Printer Setup > Paper Source Settings > Paper Conguration
6. On the paper size setting screen, select the paper size using the l or r button, and then press the OK button.
On the paper type setting screen, select the paper type in the same way, and then press the OK button.
Conrm the settings, and then press the OK button.
Note:
You can also display the paper size and paper type settings screen by selecting the following menus.
Setup > Printer Setup > Paper Source Settings > Paper Setup
7. Slide out the output tray and then raise the stopper.
User's Guide
Loading Paper
24