13
Changing the Projected Image
Use the following methods to switch images for projection.
• Switching by source search
The projector automatically detects signals being input from
connected equipment, and the image being input from the equipment
is projected.
• Direct switching
Switch by pressing the button for the target input port on the remote
control.
Switching by Automatic Detection of Input Signal
(Source Search)
You can project the target image quickly because the [Source Search]
button skips input ports where no image is being input.
When your video equipment is connected, start playback before beginning
this operation.
When two or more pieces of equipment are connected, press the
[Source Search] button until the target image is projected.
Computer VideoS-Video
Slideshow
*
USB Display
HDMI
*
Procedure
Using the remote control
Using the control panel
To Next Page
Loading...
Need help?
General
