Epson EPL-N4000 - Attaching the Power Cord

17
Flamingo
Rev. C
A5 size SETUP2.FM
11/5/98 Pass 0
R
Proof Sign-off:
M.Takata _______
K.Nishi _______
K.Pipa _______
4
Attaching the Power Cord
1. Make sure the power switch on the top of the printer is turned
off, as shown below.
2. Insert the power cord into the AC inlet at the back of the
printer. Then plug the other end into a properly grounded
outlet.
c
Caution:
❏
Avoid using outlets that other appliances are plugged into.
❏
Only use an outlet that meets the power requirements for
this printer.