Epson ET-4700 Series - Paper Feeds at a Slant; Several Sheets of Paper Are Fed at a Time; Paper out Error Occurs; Original Does Not Feed in the ADF

❏ Load one sheet of paper at a time if you have loaded several sheets of paper.
Related Information
& “Removing Jammed Paper” on page 169
& “Loading Paper in the Rear Paper Feed” on page 49
Paper Feeds at a Slant
Load paper in the correct direction, and slide the edge guides against the edges of the paper.
Related Information
&
“Loading Paper in the Rear Paper Feed” on page 49
Several Sheets of Paper are Fed at a Time
❏ Load one sheet of paper at a time.
❏ When several sheets of paper are fed at a time during manual 2-sided printing, remove any paper which is
loaded in the printer before you reload the paper.
Paper Out Error Occurs
When a paper out error occurs although paper is loaded in the rear paper feed, reload paper in the center of the
rear paper feed.
Original Does Not Feed in the ADF
❏ Use originals supported by the ADF.
❏ Load originals in the correct direction, and slide the ADF edge guides against the edges of the originals.
❏ Clean the inside of the ADF.
❏ Do not load originals above the line indicated by the triangle symbol on the ADF.
❏ On the screen for copy, scan, or fax, check that the ADF icon is on. If it is o, place the originals again.
User's Guide
Solving Problems
174