Open the front paper guide by
pulling the tab at the center of it, and
then remove the guide by grasping
both sides and pulling it straight out
of the printer.
Open both sprocket covers, and fit
the first four holes of the paper,
printable side up, over the tractor
pins. Then close the sprocket covers.
Note:
Load continuous paper that has a clean,
straight edge to avoid paper jams.
tab
Loading Continuous Paper Onto the Front Push Tractor
1
2
2
To load continuous paper onto the front push tractor, follow these steps:
To remove any paper from the paper
path, press the
Load/Eject
button.
The printer feeds the paper into the
standby position, where you can
remove the paper from the printer.
If you load continuous paper of a
different size or thickness, you need
to adjust the position of the sprockets
or change the paper thickness lever
setting. See Chapter 2 of the User’s
Guide for instructions.
To Next Page
Loading...
Need help?
General
