Setting up the Scanner 13
R
R4CA100
Setup Guide Rev. D
SETUP.FM A5 size
12/9/03
Proof Sign-off:
KOW M. Tago K. Yoda
T. Takahashi
NOC K. Lee
Setting the SCSI ID number
The scanner's default SCSI ID number is 2.
If you add the scanner to a system in which one of your SCSI
devices already has a SCSI ID of 2, change the ID number to an
unused number using the rotary switch. See the table below as a
guide.
Caution:
Do not set the SCSI ID to an ID number that is already assigned
to another device otherwise the computer, scanner, and other
devices will not operate properly.
ID Availability Description
0, 1 Not recommended Usually used for hard disk
2 Available Factory setting of the scanner
3-6 Available
7 May not be available Usually used for the SCSI board
The SCSI ID
rotary switch
To Next Page
Loading...
