Setting up the Scanner 15
R
R4CA100
Setup Guide Rev. D
SETUP.FM A5 size
12/9/03
Proof Sign-off:
KOW M. Tago K. Yoda
T. Takahashi
NOC K. Lee
Connecting the scanner
Connect the scanner to your computer or to another SCSI device
as follows:
Note:
The combination of connectors on the SCSI interface cable you need
varies depending on the maker of your SCSI device and SCSI interface
board.
1. Make sure the scanner, computer, and all other SCSI devices
are turned off and unplugged from the power source.
Caution:
Do not connect the scanner to the computer or other devices
while they are turned on as damage may occur.
2. Connect one end of the interface cable to one of the scanner
SCSI connectors until the locks on both sides snap in.
Note:
❏ To connect the scanner to a PC or any other SCSI device, the
total length of cable in the daisy chain must not exceed 3 meters;
otherwise the system may not work properly.
❏ When using the SCSI interface, do not use other interfaces such
as USB or IEEE at the same time.
SCSI interface connector
To Next Page
Loading...
