Epson GT-2500 and GT-2500 Plus
7/06 Epson GT-2500 and GT-2500 Plus - 3
Loading Documents in the Automatic
Document Feeder
You can load up to 50 sheets of paper in the ADF (a stack
thickness of 0.2 inches [5.0 mm] or less). See “Document
Specifications” to the right for details.
Only load sheets that are all the same size.
Caution:
Do not feed photographs or valuable original artwork into the ADF.
Misfeeding may wrinkle or damage the original. Scan high-quality
color or halftone documents on the document table instead.
Remove any documents from the document table and make sure
there is no dust on the glass before loading documents in the ADF.
1. Extend the paper support at the end of the output tray on
the ADF.
2. Slide the edge guides on the input tray of the ADF all the
way outward.
3. Place your document in the input tray with the printed side
facing up and the top edge facing into the feeder. Slide the
paper into the feeder until it meets resistance.
Then slide the edge guides over to the edge of the paper.
Document Specifications
The table below listed the sizes of paper you can load in the
ADF.
Load only documents that meet the following specifications in
the ADF:
Make sure your documents meet the following conditions
before loading them into the ADF:
❏ The ink is dry.
❏ The document has no holes and is not ripped or wrinkled.
❏ The document has no staples, paper clips, or other objects
attached to it; these may damage the feeder mechanism.
❏ The document has no folds.
❏ The document has no cut-out areas.
❏ The document is not a multipart form or bound.
❏ The document has no rear carbon coating.
Paper name Size
Letter 8.5 × 11 inches (215.9 × 279.4 mm)
A4 8.3 × 11.7 inches (210 × 297 mm)
Legal 8.5 × 14 inches (215.9 × 355.6 mm)
B5 7.2 × 10.1 inches (182 × 257 mm)
A5 5.9 × 8.3 inches (148.5 × 210 mm)
Size Width: 5.9 to 8.5 inches (148.5 to 215.9 mm)
Length: 5.9 to 14 inches (148.5 to 355.6 mm)
Weight 60 to 105 g/m
2
Paper type High-quality bond paper
To Next Page
Loading...
Need help?
General
