Epson LQ-1070 - Changing the Printhead

REV.-B
3.2.1 Changing the Printhead
1. Remove the FRAME ASSY., SHEET GUIDE.
2. Remove the COVER
ASSY., EJECT.
HEET GUIDE
ASSY., EJECT
“(This illustration shows the
LQ-570,
an 80-column printer. The difference
between the
LQ-570 and the LQ-
1070 is only in carriage width.)
Figure 3-2. Removing the FRAME ASSY., SHEET GUIDE and the COVER ASSY., EJECT
3. Release the two levers that hold the
printhead to the carriage. Lift out the printhead.
4. Remove the two FFCS (CABLE, HEAD, FRONT(,REAR)) from the printhead.
CAB1
Figure 3-3. Removing the Printhead
3-5