Epson LQ-570+ - Removing Continuous Paper from the Pull Tractor; Paper-Thickness Lever

Epson LQ-570+ Printer Operation Removing Continuous Paper from the Pull Tractor
Printer Setup Manual Epson LQ-570+ Printer Operation - Page 11
SDX ACD Manager 5.2 38DHB0002UKBP - Issue 1 (March 1999)
Removing Continuous Paper from the Pull Tractor
1. To remove continuous paper when using the pull tractor, tear off the paper at a
point before it enters the paper slot.
2. Press the
LF/FF
button to feed the remaining paper forward, out of the printer.
Paper-Thickness Lever
Set the paper-thickness lever to match the thickness of your paper according to the
table below.
Paper Type Lever Position
Ordinary paper (with film ribbon) -1
Thin paper -1 or 0
Ordinary paper (single sheets or continuous) 0
Multi-part forms (carbonless)
– 2 sheets (original + 1 copy)
– 3 sheets (original + 2 copies)
– 4 sheets (original + 3 copies)
1
2
2 to 3
Labels 2
Envelopes 2 to 5
Note:
Print speed is reduced for paper-thickness lever settings of 2 and above.