SETTING UP YOUR PRINTER
Epson LQ 590 Dot Matrix printer - Windows 7
UNPACK YOUR PRINTER AND LOAD THE DRIVERS
After you have unpacked your printer, removed all the packing tape and connect your printer to your computer
with a cable. Find your printer’s owner’s manual. You will need this manual for installing the printer for use.
INSTALLING YOUR PRINTER DRIVERS INTO WINDOWS
Follow the directions to install the printer drivers from the supplied CD in the owner’s manual. There is a CD
disk that comes with each printer.
At the end of the installation for Windows, you will be asked if you want to; PRINT A TEST PAGE. Print out
a test page to make sure the printer is working correctly.
IF THE PRINTER FAILS TO RESPOND AND DOES NOT PRINT A TEST PAGE, CALL THE
VENDOR THAT PROVIDED THE PRINTER, OR CALL THE PRINTERS MANUFACTURER.
Your printer should be listed automatically in the printer windows. To check to see if it is installed
correctly;
Step 1 – Click Start Button
Step 2 – Click Control Panel
Step 3 – Click Printers
The next window will appear you should see “Epson LQ590” listed as a printer.
To Next Page
Need help?
General
