Start Here
Continued Continued on back
Unpacking
Assembling the Printer
1
Remove all protective tape
power cord
It may come attached to the
printer in some countries.
The shape of the plug may vary
by location.
2
c
Caution:
Do not touch the white cable inside the printer.
Attach the paper guide.
Confirm the (OFF)
Open
Move the print head slightly to
the right.
Pull the ribbon guide from
the cartridge.
ribbon guide
c
Caution:
Do not tear off the clear film on the
ribbon guide. Doing so may cause
paper jams or printer malfunctions.
Insert the ribbon cartridge into the printer.
Press both sides of the cartridge firmly to fit
the plastic hooks into the printer slots.
Hold the ribbon guide and slide the protruding
parts on both sides into the slots of the print
head until it clicks in place.
Turn the ribbon-tightening knob to help feed
the ribbon into place; it should not be twisted or
creased.
Close the paper bail and the printer cover.
Pull the paper bail
forward.
Flip the paper bail
forward you.
To Next Page
Need help?
General
