- 12 -
Section 3: Removing the Front Cover
Removing the Front cover is necessary to access the
Label Clamping Assembly and to replace the left and
right ink pads.
1. Remove the Top Cover (Refer to
Section 1).
2. Remove two T10 Torx screws.
3. Loosen the Phillips head screw on the bottom of the
Printer.
4. Loosen the top Phillips head screw which is
attached to the Front Cover from behind.
Note: When replacing this screw, do not over
tighten! Over tightening will result in problems
replacing the Top Cover.
To Next Page
Loading...
