- 4 -
Section 2: Replacing the Print Module
• Part Number 660200
1. Remove the Top Cover. Refer to Section 1 for
instructions.
2. Remove two T10 Torx screws as shown.
3. Remove the USB Cable from the Main Board.
4. Remove three Phillips screws as shown.
5. Remove the USB Connection.
6. Remove the metal Board Cover.
(Steps 4-6 are not necessary for units with
Serial Numbers greater than 2050300000. It is
necessary to remove this cover on earlier models
because it allows access to a screw that is not present
on later models)
To Next Page
Loading...
